Install manually
Perform the following steps if you want to install Authentication Service for IBM DB2 manually without using the setupdb2.sh
script. If you already installed Authentication Service for IBM DB2, skip this section and go to Set up the GSSAPI DB2 client.
-
Perform the procedures described in Unzip and restore the Authentication Service for IBM DB2 package and Install the Authentication Service for IBM DB2 package using the platform’s installation program.
-
Copy the Authentication Service for IBM DB2 shared libraries to the appropriate DB2 locations.
Ssee Copy the plug-ins.
-
If you plan to use username/password for authentication, configure the operating system to load the username/password plug libraries.
-
If you plan to use single sign-on, configure the operating system to use the GSSAPI plug-in and set up the key table.
-
Configure DB2 to use the three plug-ins.
-
Confirm that the DB2 configuration is correct.
See Verify the set up.
Note: The Authentication Service for IBM DB2 Group plug-in does not require any set up.